Tester for diagnostics of power steering system. The device is connected to high-pressure line to measure performance of power system elements. Testing is conducted in a car without dismounting of units.
In ATTACHMENTS you will find:
Price by requestOnline presentation
|Dimensions, (L×W×H), mm||180*80*300|
To test the hydraulic system of the power steering, you must connect the MS610 to the high pressure line. To do this, disconnect from the pump a suitable pipeline, connect the fittings to the pump and the mains, connect these fittings to the high-pressure hoses of the device. Next, you need to turn on the car's ignition and start the engine, since the HPS pump is activated by means of a belt or gear transmission from the engine's crankshaft.
Inspection of the steering system is carried out with power steering testing machine at idle speed of the engine. The rotation of the pump shaft in this mode is sufficient to obtain the required capacity of the test unit.
Further, the pressure gauge readings are taken while MSG MS610 open. The rudder is rotated from one end position to the other. In the extreme positions (hold no more than 5 seconds), the pressure in the system should be maximum and correspond to the pressure created by the pump with the device crane locked.
How to determine the wear in the central part of the hydraulic cylinder (hydroblow)?
A sharp deviation of the arrow of the manometer MS610, when turning the steered wheels from one extreme position to the other, will indicate the presence of ring wear in the middle part of the hydraulic cylinder of the steering rack.